https://wiki.mye28.com/index.php?action=history&feed=atom&title=M30_Cooling_System_BleedingM30 Cooling System Bleeding - Revision history2026-09-08T20:53:57ZRevision history for this page on the wikiMediaWiki 1.43.8https://wiki.mye28.com/index.php?title=M30_Cooling_System_Bleeding&diff=343&oldid=prevTig: Add M30 cooling system bleeding FAQ from forum t=583682026-08-13T22:12:01Z<p>Add M30 cooling system bleeding FAQ from forum t=58368</p>
<p><b>New page</b></p><div>By [[spinedocab]], Fri Jan 23, 2009<br />
<br />
Original thread: [https://forums.mye28.com/viewtopic.php?t=58368 M30 cooling system bleeding]<br />
<br />
A reliable way to bleed the cooling system on the M30 ("big six"). The procedure is from Jim Rowe at Metric Mechanic. It also works on the M20, with one filling note below.<br />
<br />
__TOC__<br />
<br />
== Procedure ==<br />
# After the repair, '''before''' adding coolant, remove the bleeder screw and run a small piece of wire down the hole to dislodge mineral deposits.<br />
# Put the screw back, but leave the valve '''open'''.<br />
# Open the heater control valve and add coolant until it begins to escape from the bleeder hole.<br />
# Close the bleeder screw. Put the expansion-tank cap on and tighten it.<br />
# Disconnect the small coolant hose that runs from the radiator to the expansion tank '''at the expansion tank'''. Hold that hose up as high as you can. This is the "small elevated hose" — it is still attached to the radiator.<br />
# Attach a spare hose to the expansion-tank nipple you just uncovered. '''Gently''' blow through that spare hose until coolant comes out of the elevated radiator hose.<br />
# Remove the blow hose and reconnect the radiator hose to the expansion tank.<br />
# Top the expansion tank to the full mark.<br />
# Start the engine, warm it up, and check for leaks.<br />
<br />
The spare hose is extra — it is not one of the hoses already on the car. Keep the tank reasonably full and the cap on while you blow.<br />
<br />
The bleeder is on top of the thermostat housing: look at the fan, then about 4 inches back toward the engine. 8 mm wrench. ([[wkohler]], photo in the [https://forums.mye28.com/viewtopic.php?t=58368 thread])<br />
<br />
== M20 / a fully drained system ==<br />
The same method works on M20s. If the system is completely empty, start filling from the radiator end of the top hose so the block fills from the bottom (and fills faster). Blowing into the bottle with the bleeder still open can move the last pockets of air. Try not to ingest antifreeze. ([[nutgone]])<br />
<br />
== From the discussion ==<br />
Clarifications of the "blow hose" vs the elevated radiator hose are from [[spinedocab]]'s later reply in the same thread. M20 filling note from [[nutgone]]. Bleeder location from [[wkohler]] via [[Fuel]].<br />
[[Category:Tech FAQ]]</div>Tig